This gimbal can be mounted on any moving object such as car or smooth surface to get perfectly leveled image. The high speed IMU gives you a ultra smooth gimbal straight out the box with no setup required. The G3 2-Axis brushless phantom mount gimbal.Is perfect for Gopro hero 4, 3, 3+ camera, but can also be used with many other similar sized cameras, and compatible with Phantom 2 Vision+, Phantom 2 Vision, Phantom 2, Phantom FC40, Phantom 1, Spreading Wings S1000, Spreading Wings S900, Spreading Wings S800 EVO, Spreading Wings S800, Flame Wheel ARF KIT. On the gimbal circuit board there are Up and Down button, by pressing them you can control the tilt angle, no RC system is required! TILT and ROLL can be control by receiver input. You can also connect a servo lead from your receiver to remotely control the Up and Down view of the gimbal. Note:You should first amount the GOPRO to gimbal, then put on the batteries and power on. Otherwise it will cause the phenomena of gimbal disorderly shaking. Specifications: Weight : 178 grams Power Input: 3S or 4S lipo input (8 volt to 18 volts) Onboard button to adjust pitch angle RC input to control Pitch and Roll angles via RC Radio Roll control Angle: + 55 to - 55 degrees Pitch control Angle: + 60 to - 180 degrees Stabilization Angle range: 0 degrees (remains level) Stabilization Roll range: -90 to +30 degrees Note: Camera not included. Package Contents: 1x G3 Gimbal 2x 55mm Spacing Hooks and screws 4x Extra damper balls 1x USB to TTL dongle 1x USB dongle cable 1x RC receiver connection wire 1x Power wire 1x Installation Instructions. This item is 100% Brand New. The item "Neewer G3 2-Axis Brushless Gimbal With Phantom Mount for GoPro 3 3+ 4" is in sale since Wednesday, September 27, 2017. This item is in the category "Cameras & Photo\Tripods & Supports\Stabilizers". The seller is "emilyandlily" and is located in edison 08817. This item can be shipped to United States.